![]() ![]() 2nd Step - Remove the ramrod from the thimbles.3rd Step - Close the swinging breech and remove both the front and rear stock/lug assembly screws by turning them counter clockwise. (This is covered later in the text) If you can see light, proceed as follows. If you can not see through it, it is charged or the channel is obstructed and it will be necessary for you to remove the breech plug. Next, holding the muzzle up to the light, look through the ignition fire channel to make sure you can see through it. This will expose the primer pocket in the. To ensure that the gun is unprimed and uncharged, lower the swinging breech block to open the action by pivoting the trigger guard forward. This is recommended for a thorough cleaning of the rifle if it has undergone use in pouring rain or snow, or at seasons end, but it is not necessary for normal or routine maintenance.1st step - Make sure that the gun is unprimed and uncharged. The Stock Assembly - molded composite material or wood.Note: The barrel and action assembly can be broken down further by removal of the trigger/action assembly. This assembly is held in the stock by two stock screws one is located about 1' in front of the trigger guard, and the other is approximately 4' ahead of the first.2. Last Updated on Sat, Swinging BreechFiring Pin-Hammer-TriggerTrigger Guard SpurTriggerAssembly & Disassembly Of The T/C OmegaThis T/C has two (2) basic parts groups:1. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |